Safety: Laser Printer; Safety: When Working Inside Your Device; Safety: General Power Safety - Dell B1160w Wireless Mono Product Information Manual

• If your device includes a modem, the cable used with the modem should be manufactured
with a minimum wire size of 26 American wire gauge (AWG) and an FCC compliant
RJ-11 modular plug.
• Do not spill food or liquids on your equipment.
• Before you clean your equipment, disconnect it from the electrical outlet. Clean your
device with a soft cloth dampened with water. Do not use liquids or aerosol cleaners, which
may contain flammable substances.
• Clean the Printer display with a soft, clean cloth and water. Apply the water to the cloth,
then stroke the cloth across the display in one direction, moving from the top of the
display to the bottom. Remove moisture from the display quickly and keep the display dry.
Long-term exposure to moisture can damage the display. Do not use a commercial window
cleaner to clean your display.
WARNING:
internal covers, bezels, filler brackets, front-panel inserts, etc.) removed.
• If your equipment does not operate normally - in particular, if there are any unusual
sounds or smells coming from it - unplug it immediately and contact an authorized dealer
or service center.

SAFETY: Laser Printer

Dell Laser Printers comply with safety requirements and are classified as Class 1 Laser Products,
under the US DHHS Standard and IEC/EN60825-1 Laser Safety Standard. The radiation from
the lasers emitted inside the printer is completely confined within protective housings and
external covers, and the laser beam cannot escape during any phase of normal user operation.
WARNING:
those specified in your user documentation or in instructions provided to your by Dell may
result in exposure to hazardous radiation.

SAFETY: When Working Inside Your Device

Do not attempt to service the equipment yourself, except as explained in your Dell
documentation or in instructions otherwise provided to you by Dell.
Always follow installation and service instructions closely.

SAFETY: General Power Safety

Observe the following guidelines when connecting your equipment to a power source:
• Check the voltage rating before you connect the equipment to an electrical outlet to
ensure that the required voltage and frequency match the available power source.
• Also, ensure that your printer and attached devices are electrically rated to operate with
the AC power available in your location.
10
Product Information Guide
Do not operate your equipment with any cover(s) (including external or
Using controls, making adjustments, or performing procedures other than