Enabling and Disabling Protocols Using the Control Panel
1.
Log in as the network administrator from the control panel.
2.
Press [System Settings].
3.
Press [Interface Settings].
4.
Press [Effective Protocol].
5.
Set the desired protocols to active/inactive.
6.
Press [OK].
7.
Log out.
Enabling and Disabling Protocols Using Web Image Monitor
1.
Log in as the network administrator from Web Image Monitor.
2.
Point to [Device Management], and then click [Configuration].
3.
Click [Network Security] under "Security".
4.
Set the desired protocols to active/inactive (or open/close).
5.
Click [OK].
Enabling and Disabling Protocols
121