Recalling And Configuring A Logo - Extron electronics ISS 506 User Manual

Switcher Software, cont'd
Figure 5-9 — Capturing Logo window
N The program does not allow you to enter a dot (period) and automatically
5.

Recalling and configuring a logo

Recall and configure a logo as follows:
1.
2.
Figure 5-10 — Selecting Logo window
3.
4.
5.
N As a simpler alternative, if you selected the Key Type Color radio button, you
5-10 ISS 506 Integration Seamless Switcher • Switcher Software
can take a few minutes.
assigns the *.bmp extension.
If necessary, click (deselect) the Yellow Border checkbox to turn off the crop
marks:
Click the appropriate Logo radio button in the Logo Setup area to select a logo
to which to assign the image.
Click on the desired image's file name in the Select Logo field. Click the Select
Logo button to load the image to the Logo button. The program displays a
window that shows the progress of the selection (figure 5-10). Depending on
the size of the logo, this can take a few minutes.
When the selection is complete:
• The image assigned to the logo button is shown in blue in the Select Logo
field.
• The logo is displayed on the selected output.
• The Logo Setup Screen shows the logo's relative size and location (the logo
is in green).
Click and drag the center of the logo in the Logo Setup Screen to center the
position the logo as desired.
Click the desired method (Color or Luma) for keying out the unwanted
material from the logo in the Key Type field.
Watch the logo on the connected output device while you click the up
arrows ( ) and down arrows ( ) in the Key Type field to key out unwanted
material, such as the background, from the logo.
can click the Pick Color button. The program pops up a window containing the
logo and a color picker cursor (figure 5-11).