Advertisement
MGP 641 xi Series • Setup Guide (Continued)
Setting Up the MGP 641 xi Series Using the Front Panel
After installing and connecting the MGP, use the front panel controls to configure and
adjust the unit for use. Press the MENU button to access the Main Menu (shown at right).
Then, repeatedly press the MENU button to cycle through the menus and access the Input
Configuration, Output Configuration, and Advanced Configuration menus to perform
steps 1 through 4.
Use the Input Configuration menu to configure inputs 1 through 4, including EDID
1.
selection, aspect ratio selection, HDCP authorization, input format (SDI xi only), and
image rotation (available only for inputs 2 and 4). Some of these settings may require
about 3 seconds to take effect after selection.
Use the Output Configuration menu to configure the outputs, including signal type,
2.
resolution and rate, HDCP Note (encryption notification), TP and HDMI format, and
display rotation.
From the Advanced Configuration menu, Test Pattern submenu, use the crop and
3.
grayscale test patterns to adjust the display settings.
Use the front panel menu system to set the IP address for the unit:
4.
Press the MENU button repeatedly until the View Com Settings menu name is
a.
displayed on the LCD screen.
Press and hold the NEXT button until the LCD screen displays Edit Comm
b.
Settings.
Press the NEXT button repeatedly until IP Address appears on the LCD screen.
c.
Rotate the horizontal ADJUST knob (
d.
to edit, and the vertical ADJUST knob (
number.
Repeat step d for the remaining octets.
e.
Use the picture control buttons to size and position each window as desired for your
5.
application.
Save each window configuration to any of the 128 window preset slots for easy recall
6.
of window settings.
Saving and Recalling Presets
To save the current configuration as a preset:
Press and hold the PRESET RECALL/SAVE button until the LCD screen displays
1.
Window Preset/Save to #nnn (approximately 2 seconds). The button lights orange.
Rotate either ADJUST knob to select the preset number or name to which you want to
2.
save this configuration.
Press the ENTER button. The button lights orange. Both the PRESET RECALL/SAVE and
3.
the ENTER buttons remain lit until the preset is saved, then turn off.
To recall a saved preset, press the PRESET RECALL/SAVE button and
immediately release it. The button lights orange, and the LCD window displays
Window Preset/Recall #nnn. Rotate either ADJUST knob to select a preset number,
then press ENTER. The ENTER button lights orange and remains lit until the window preset
is recalled, then both buttons turn off. The LCD window displays WINDOW PRESET #nnn
Saved.
4
[
) to select a section of the address (octet)
{
) to increase or decrease the selected
Power
On
30 sec.
Extron
60-1574-1n
MGP 641 xi [SDI]
2 sec.
FW n.nn.nnnn
Default
Cycle
MENU
Input
Configuration
30 sec.
MENU
Output
Configuration
30 sec.
MENU
Window
Configuration
30 sec.
MENU
Image/Logo
Configuration
30 sec.
MENU
Advanced
Configuration
30 sec.
MENU
View Comm
Settings
30 sec.
MENU
NEXT
Hold 5 sec.
Edit Comm
Settings
30 sec.
MENU
Exit Menu
MENU
Press NEXT
30 sec.
NEXT
2 sec.
Advertisement
