Ethernet Link; Ethernet.connection; Default Address - Extron electronics ISS 506 User Manual

SIS Programming and Control, cont'd
™

Ethernet Link

The rear panel Ethernet connector on the switcher (figure 4-3) can be connected
to an Ethernet LAN or WAN. This connection makes SIS control of the switcher
possible using a computer connected to the same LAN or WAN.
Figure 4-3 — RJ-45 connector pinout table
Ethernet connection
The cable can be terminated as either a patch cable or a crossover cable (figure 4-3)
and must be properly terminated for your application:
• Patch (straight) cable — Connection of the ISS to an Ethernet hub, router, or
• Crossover cable — Direct connection between the ISS and a computer

Default address

To access the switcher via the LAN port, you need the switcher's IP address. If
the address has been changed to an address comprised of words and characters,
the actual numeric IP address can be determined using the front panel (see
"IP information" in chapter 3, "Operation") or the Ping utility (see "Ping to
determine the switcher's IP address" or "Ping to determine the Web IP address" in
appendix A, "Ethernet Connection", for more details). If the address has not been
changed, the factory-specified default is 192.168.254.254.
4-4 ISS 506 Integration Seamless Switcher • SIS
Side Clip Down
Pins 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1&2 7&8
3&6 4&5
switcher that also hosts a controlling computer
Patch (straight) cable
Side 1
Pin Wire color
1 White-orange
2 Orange
RJ-45
connector
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Crossover cable
Side 1
Pin Wire color
1 White-orange
2 Orange
Twisted
Pairs
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Programming and Control
™
Side 2
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Side 2
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown