Serial.port.connection; Reset Button - Extron electronics ISS 506 User Manual

Installation, cont'd
Serial port connection
l
Figure 2-14 — Remote port pin assignments

Reset button

m
N IP settings reset does not replace any user-installed firmware.
2-10 ISS 506 Integration Seamless Switcher • Installation
Remote port — Connect a host device, such as a computer
or touch panel control, to the ISS 506 Integration Seamless
Switcher via this 9-pin D connector for serial RS-232 or RS-422
control (figure 2-14).
Pin RS-232 Function
1 —
2 TX
3 RX
RS232/422
4 —
5 Gnd
6 —
7 —
8 —
9 —
See chapter 4, "SIS Programming and Control", for definitions of the SIS
™
commands and chapter 5, "Scaler Software", to install and use the control
software.
Reset button — The Reset button initiates four levels of reset to the matrix
switcher. Use and Extron Tweeker or small screwdriver to press and hold the
button while the switcher is running or while you power up the switcher, for
different reset levels.
See "Reset button" in chapter 3, "Operation", for details.
• Events (mode 3) reset — Hold Reset for 3 seconds, then release it and
push it again to toggle events monitoring on and off.
• IP settings (mode 4) reset — Hold Reset for 6 seconds, then release it and
push it again to reset the switcher's IP functions.
• Absolute (mode 5) reset — Hold Reset for 9 seconds, then release it and
push it again to restore the switcher to the default factory conditions
(without resetting the firmware).
• Hard reset — Hold Reset while powering up the switcher to revert to
the factory default firmware (in the event that firmware incompatibility
issues occur).
RS-422 Function
Not used — Not used
Transmit data TX– Transmit data (–)
Receive data RX– Receive data (–)
Not used — Not used
Signal ground Gnd Signal ground
Not used — Not used
Not used RX+ Receive data (+)
Not used TX+ Transmit data (+)
Not used — Not used
LAN
RESET