Selecting An Input To Be The Preview Output And Switching It To The Program Output - Extron electronics ISS 506 User Manual

Operation, cont'd
Selecting an input to be the preview output and switching it to
the program output
N In this example, the switcher is set to Swap mode. See "Preview Switch Mode
1.
Figure 3-20 — Selecting an input
2.
Figure 3-21 — Cutting to the selected input in Swap mode
3-28 ISS 506 Integration Seamless Switcher • Operation
submenu", earlier in this chapter.
Press and release a preview input button (figure 3-20).
Press and release the Preview 3 button.
The Preview 3 button lights green to indicate that input 3 is
selected and the video is scaled and output as the preview output.
N The Program 6 button indicates that input 6 is selected
as the program output.
PROGRAM
3 4
1 2
FREEZE
PREVIEW
3 4
1 2
FREEZE
= Lit button = Unlit button
Press and release either the Cut or Take button.
Cut button — The ISS immediately switches the input selected as the preview
output to the program output and the input selected as the program output to
the preview output (figure 3-21). No switching effects are added.
Press and release the Cut button.
TRANSITION
If the Wipe or Dissolve effect is selected (lit):
The Preview 3 button goes out and the Program 3 button lights green.
TAKE
CUT
The Program 6 button goes out and the Preview 6 button lights green.
EFFECTS
PIP
WIPE 1
FREEZE
DISSOLVE TITLE
1
FREEZE
= Lit button
If the PIP or Title effect is selected (lit):
The Preview 3 button and the Program 6 button remain lit.
The Take button blinks until you press Cut or Take to turn off the PIP
or title effect.
Take button — The ISS switches the input selected as the preview output
to the program output using the effect selected by one of the Effect buttons
(figure 3-22).
6
5
LOGO 2
LOGO 1
/BLACK /BLACK
5 6
LOGO 1 LOGO 2
/BLACK /BLACK
PROGRAM
3
2 4 5 6
LOGO 1
/BLACK
PREVIEW
3 4
2 5 6
LOGO 1
/BLACK
= Unlit button
LOGO 2
/BLACK
LOGO 2
/BLACK
= Blinking button
TAKE