Erase Submenu; Advanced.configUration.menu - Extron electronics ISS 506 User Manual

N The color, tint, contrast, brightness, detail, sizing, and centering settings are
User presets are recalled using the Input buttons. See "Input buttons", earlier in
this chapter, for instructions on recalling a user preset.

Erase submenu

Rotate the Adjust [ while the Erase submenu is active to select Program or
Preview. Rotate the Adjust { knob to highlight (< >) one of three memory presets
for the selected output or highlight N/A for no preset Press the Next button to
erase the user preset. Highlight N/A and press the Next button to exit without
erasing.
Advanced Configuration menu
Figure 3-13 is a flowchart that shows an overview of the Advanced Configuration
menu, the submenus, and the available settings.
Default
Cycle
Menu
Menu
30 sec.
Auto
Image
Menu
Input
Configuration
Menu
Output
Configuration
Menu
Effects
Configuration
Menu
Logo
Capture
Menu
User
Presets
Menu
Next
Advanced
Configuration
Menu
View Comm
Settings
Menu
* This menu is available
Scan Converter
only if the optional
*
Configuration
scan converter board
is installed.
Menu
Exit Menu
Press Next
Menu Next
Figure 3-13 — Advanced Configuration menu flowchart
tailored for the selected output rate. If you change the output rate and then
recall a preset for the earlier rate, the adjustments recalled in the preset have
no effect on the video output. However, if you then change back to the earlier
output rate, the effects of the adjustments appear on the screen if they were not
overwritten for the old output rate.
30 sec.
Next
Auto Image
Input#1 Off
Input #1 Off or On
through
input #6.
30 sec.
Next
Blue Mode
< >
Off On
0.0 to 5.0 seconds in
0.1-second increments.
Preview Switch
<
Swap
ISS 506 Integration Seamless Switcher • Operation
30 sec.
Next
Test Pattern Off
Split Color Bars
• Off • Split Color Bars
• Preview • Crosshatch 4:3
• Program • Crosshatch 4x4
• Both • Split Gray Scale • Aspect 1.85
• Ramp
• Alternating Pixels
30 sec.
RGB Delay Auto Memories
Next
0.4 Seconds
Off
30 sec.
Next
Reset to Factory
>
Press Detail
Stay
• Crop
• Aspect 1.33
• Aspect 1.78
• Aspect 2.35
30 sec.
Next
< >
On
30 sec.
Next
3-19