Programming The Mmsi - Standard Horizon ECLIPSE DSC+ GX1200E Owner's Manual

9.2.2 Programming the MMSI

The MMSI can be input only once. Therefore, please be careful
not to input the incorrect MMSI number. If you need to change the
MMSI number after it has been entered, the radio will have to be re-
turned to Factory Service. Refer to the section "12.2 FACTORY SER-
VICE."
1. Press and hold the
" SETUP MENU " appears.
2. Press the
SETUP ".
3. Press the
press the
4. Press the
number of your MMSI, then press the
soft key to step to the next
number.
5. Repeat step 4 to set your MMSI number
(nine digits).
6. If a mistake was made entering in the
MMSI number, press the
key until the wrong number is selected,
then press the
the entry and press the
7. When finished programming the MMSI
number, press and hold the
key. The radio will ask you to input the
M M S I n u m b e r a g a i n . U s e s t e p s 4
through 6 above.
8. After the second number has been
input, press and hold the
store the MMSI.
9. Press the
10. Press the
and return to radio operation mode.
GX1200E
WARNING
key until the
key to select " MMSI
/
soft key. (To cancel,
soft key.)
/ key to select the first
/ key to correct
soft key to return to the setup menu.
key or press the
-SETUP MENU-
DSC SETUP
POS INPUT
MMSI SETUP
-USER MMSI-
INPUT MMSI
ID:1--------
soft
-USER MMSI-
INPUT AGAIN
ID:---------
soft key.
soft
-USER MMSI-
STORED ID
123456789
soft to
soft key twice to exit the menu
-USER MMSI-
INPUT MMSI
ID:---------
-USER MMSI-
INPUT MMSI
ID:123456789
-USER MMSI-
INPUT AGAIN
ID:123456789
Page 33