Electrical Connections - Standard Horizon ECLIPSE DSC+ GX1200E Owner's Manual

6.3 ELECTRICAL CONNECTIONS

Reverse polarity connections will damage the radio!
Connect the power cord and antenna to the radio. Antenna and Power
Supply connections are as follows (see Figure 1):
1. Mount the antenna at least 1 m away from the radio. At the rear of the
radio, connect the antenna cable.
2. Connect the red power wire to a 13.8 VDC ±20 % power source. Connect
the black power wire to a negative ground.
3. If an optional remote extension speaker is to be used, refer to next
section for connections.
4. It is advisable to have a Certified Marine Technician check the power
output and the standing wave ratio of the antenna after installation.
Antenna
Red
Power Source
Page 14
CAUTION
Optional Speaker
Accessory Cable
Water proof
Deck Outlet
Fuse
Black
Figure 1. General Installation
GPS Navigation Receiver
SC
EC LIP SE D
DIST RES S
PULL OPEN
GX1200E