External Speaker Connection; Fuse Replacement - Standard Horizon ECLIPSE DSC+ GX1200E Owner's Manual

Ferrite Core Installation
To suppress RF interference
that can cause abnormalopera-
tion of the transceiver, attach the
supplied ferritecore to the both

External Speaker Connection

Cable and GPS Connection Cable
together, then snap its two halves-
together, per the illustration below.
Attach the ferrite core as close as
possible to thetransceiver body, as shown. Finally, wind some plastic tape
around the ferrite core, toprevent vibration from causing the two halves to
split apart.

Fuse Replacement

To take out the Fuse from the Fuse Holder,
hold both ends of the Fuse Holder and pull
the Fuse Holder apart, do not bend the Fuse
Holder. When you replace the Fuse, please
confirm that the Fuse is tightly fixed on the
metal contact located inside the Fuse Holder.
If the metal contact holding the fuse is loose,
the Fuse holder may heat up.
GX1200E
As close as possible
DC Power Cable (RED)
DC Power Cable (Black)
External Speaker
Connection Cable
GPS Connection
Cable
Ferrite Core
Snap together
Page 15