Group Directory; Position Reply; Dsc Beep - Standard Horizon ECLIPSE DSC+ GX1200E Owner's Manual

10.3.5 Group Directory

For this function to operate, the same group MMSI must be programmed
into all the DSC VHF radios within the group of vessels that will be using this
feature. To understand group MMSI programming, first a ship MMSI has to
be understood.
Refer to section "9.6.1 Setting up a Group Call" for programming.

10.3.6 Position Reply

The GX1200E can be set up to automatically (default setting) or manually
send your position when requested by another vessel. This selection is
important if you are concerned about someone polling the position of your
vessel that you may not want to. In the manual mode you will see the MMSI
or persons name shown on the display allowing you to choose to send your
position to the requesting vessel.
Refer to section "9.7.1 Setting up the Position Reply" for setting.

10.3.7 DSC Beep

This feature allows the alarm beeps to be turned on (default setting) or off
when a DSC call is received. The DSC calls that can be customized are:
individual, group, all ships, position request, position report, geographical call
using the procedure below:
1. Press and hold the
MENU " appears.
2. Press the
menu.
3. Press the
BEEP " with the
4. Press the
key to the desired DSC call type and press
the soft key.
5. Press the
the DSC beep and press the
6. To exit this menu and return to radio operation
mode press the
soft key twice.
GX1200E
key until " S E T U P
key to select " DSC SETUP "
/
soft key, then select " DSC
/ key.
soft key, then press the
key to turn " ON " or " OFF "
/
key or press the
-SETUP MENU-
GENERAL SETUP
CH FUNC SETUP
DSC SETUP
-DSC SETUP-
GROUP DIR
POS REPLY
DSC BEEP
/
-DSC BEEP-
SELECT CALL
INDIVIDUAL
BEEP:ON
soft key.
-DSC BEEP-
SELECT CALL
INDIVIDUAL
BEEP:OFF
Page 83