Advertisement
Subtest 05
Card modem 100pback (Execution time: 5 seconds)
Rote: If there is no modem card in the system, this test
can not be executed. Press the Fn + SysReq key, then
confirm that the Built-in modem power is on.
This test is used to check whether the data, which
is from the modem to the RS232C inside the system,
is same as the original data which had first been
sent to the modem card.
Subtest 06
Card modem on-line test (Execution time: 10 seconds)
Rote: After the system is connected to the PBX, unless the
receive side is in the same status as the send side,
the test cannot be executed. Press the Fn + SysReq
key, then confirm that the Built-in modem power is
on.
In this test, first some data are sent to the modem
card from the RS232C
inside
the
system,
then
the
data is again sent to the other system through the
PBX (Private Branch Exchange).
This test is used whether the returned data from the
other system are same as the original data.
Subtest 07
Dial tester test (Execution time: 60 seconds)
Rote: To
execute
this
test,
a
dial
tester
must
be
connected to the system.
This test is carried out by sending the pulse dial
and tone dial twice automatically.
[Pulse dial]: "1-2-3-4-5-6-7-8-9-0-1-2"
[Tone dial]:
"1-2-3-4-5-6-7-8-9-*-0-*"
3-22
Advertisement
