Advertisement
6.
Select the subtest number.
Type
the
subtest number
then
press the Enter. The following message will appear.
When select the KEYBOARD TEST, the following message will
not appear.
TEST LOOP (1:YES/2:NO) ?
When select the (YES),
Each time a test cycle ends, it increments the pass counter
by one and repeats the test cycle ••
When select the (NO),
At the end of a test cycle, it terminares the test execution
and exits to the subtest menu.
7.
Type the 1 or 2 then press Enter. The following message will
appear.
ERROR STOP (I:YES/2:NO) ?
When select the (YES),
When an error occurs, it displays the error status and stops
the
execution
of
the
test
program.
The
operation guide
displays on the right side of the display screen.
When select the (NO),
When an error occurs, it displays the error status then it
increments the error counter by one and goes to the next
test.
8.
Type the 1 or 2 then press the Enter. The test program will
run. Each subtest names described in the part 3.3.
9.
When stop the test program, press Ctr1 + Break keys then
return to the DIAGNOSTICS MENU.
10. When error occurs on the test program, the following message
will appear.
ERROR STATUS NAME
(( HALT OPERATION ))
1: Test End
2:
Continue
3:
Retry
1: Terminates the test program execution and exits to the
subtest menu.
2: Continues the test.
3: Retry the test.
The error code and error status names described in part
3.15.
3-4
Advertisement
