Using Pilot Data - Furuno FEA-2107 Operator's Manual

16.2

Using Pilot Data

To prepare pilot data, do the following:
1. Place the cursor on PilotData in the status bar, and then click the Plan or Monitor button as appropriate. If no
pilot data is chosen, the Pilot Data menu (shown below) appears in addition to the Monitor Pilot Data dialog
box or Plan Pilot Data dialog box.
2. If no menu appears, click the same button once more to open the menu.
[Pilot Data]
Go Plan mode
Select
Unselect
Backup and Restore
Report
Close
[Pilot Data]
Go Monitor mode
Select
Unselect
Create
Backup and Restore
Report
Close
Note: If you want pilot data to be displayed on the electronic chart, make sure that pilot data options are turned on in
the Mariner page of the Chart Display dialog box.
1. 2.
i
i
Position Position marker
marker and text
Four different variations as examples of how pilot data is presented on the chart area:
1. Position marker
2. Position marker and text
3. Position marker and range marker
4. Position marker, text and range marker
Activate Monitor/Plan mode:
User can switch pilot data mode between plan and monitor. Using
Go Monitor mode> Go Monitor mode, pilot data used in the planning
mode can be switched directly to the monitoring mode. Using
Go Plan mode> Go Plan mode, pilot data used in the monitoring mode
can be switched directly to the planning mode.
Select:
Chooses pilot data to use; monitor or planning mode.
Unselect:
Unselect removes pilot data from active use.
Create:
Creates new pilot data. Pilot data can be named, using up to 30
alphanumeric characters.
Backup and Restore:
User can make backup copy from pilot data or restore from backup
media.
Report:
Generates tabulated report from chosen pilot data.
THIS IS A TEST
i
3. 4.
i
Position marker Position marker,
and range marker text, and range marker
16. Pilot Data
THIS IS A TEST
i
16-3