Installing The Blackdiamond 8810 Spare Fan Tray - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

CAUTION
Be sure that both hands are used to support the weight of the fan tray during removal.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch so that it is always available when you
need to touch ESD-sensitive components.

Installing the BlackDiamond 8810 Spare Fan Tray

To install a replacement fan tray into the BlackDiamond 8810 switch:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top left corner of the switch.
2 Support the bottom of the fan tray with one hand as you lift the fan tray by the handle using the
other hand. Align the spare fan tray with the fan tray slot on the switch, and then slide the fan tray
into place in the switch (see
CAUTION
Be sure that both hands are used to support the weight of the fan tray during installation.
Figure 145: Installing the fan tray in the BlackDiamond 8810 switch
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
Figure 145 and Figure 146).
Installing the BlackDiamond 8810 Spare Fan Tray
Fan Tray
Captive
Screws (x2)
Fan Tray
Handle
ASP030A
219