Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual page 333

2 Slide the unit completely into the chassis until the front of the EPS-600LS is flush with the surface of
the EPS-C (see Figure
3 Tighten the two captive screws on the EPS-600LS unit into the EPS-C (see
the unit in place.
Figure 236: Securing the EPS-600LS to the EPS-C chassis
! See Manual
4 Connect the AC power cord to the AC connector on the EPS-600LS unit (see
5 Use the cable clip on the EPS-600LS unit to hold the AC power cord in place (see
CAUTION
The EPS-600LS unit does not have a switch for turning the unit on and off. Disconnect power to the EPS-600LS
unit by removing the plug from the electrical outlet. Make sure that this connection is easily accessible to you.
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
236).
Tighten Screws
EPS-600LS
O.T.P
DC OK
AC OK
EPS-600LS External Power Module
Figure 236). This secures
EPS-C_05A
Figure 237).
Figure 237).
333