Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual page 352

Extreme Networks Optics
Figure 240: Accessing the XFP ports
4 Holding the module by its sides, partially insert the XFP module into one of the ports on the Summit
XGM2-2xf option card or the 10G4Xa module (see
5 Push the XFP handle (bail latch) upward until it clicks into place (see
6 Slide the XFP module as far back into the slot as possible, until you hear it click, indicating that it is
firmly attached (see
Figure 241: Installing an XFP module
Figure 242: Installed XFP Module
NOTE
If you are installing only one XFP module, make sure that all unoccupied ports are covered with a rubber dust cover,
which is shipped with the option card (see
352
Figure 241 and Figure 242).
XFP Module
Installed
XFP Module
Figure 242).
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
Summit XGM2-2xf
Option Card
XFP Ports
SH_023
Figure 241).
Figure
XFP Handle
SH_024
Cover Plate
SH_025
241).