Installing Or Removing Xfp Modules - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Summit Option Cards
Figure 212: Installing the Summit XGM2-2xf option card
6 Using the screws from the filler panel, secure the Summit XGM2-2xf option card to the back panel of
the switch.
7 Refer to "Installing or Removing XFP Modules" on page 304
replacing the XFP modules in the Summit XGM2-2xf option card.
NOTE
If you install only one XFP module in the Summit XGM2-2xf option card, attach the supplied cover plate over
the remaining open module slot.

Installing or Removing XFP Modules

This section describes installing and removing an XFP module. You can install or remove an XFP
module from your Extreme Networks switch without powering off the system.
typical XFP module.
Figure 213: XFP module
304
Summit Option
Card
Card edge
connector
for information on installing or
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
SH_014
Figure 213 shows a
XFP Module
SH_022