Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual page 199

Figure 127: Cable guide screw locations
Hinge tabs fit into cable manager base
3 Remove the six screws that secure the cable guides to the mounting base. Save the screws for
reattaching the guides later.
4 Set the cable manager mounting base against the rack above the installed BlackDiamond 10808
chassis.
Adjust the height of the cable manager base as needed to ensure proper alignment of the screw
holes. The distance between the top of the chassis and the cable manager base will be approximately
1/4-inch (6-mm) to 7/8-inch (20-mm).
5 Use six rack-mounting screws (not supplied) to mount the base onto the rack, as follows:
a On each side, insert the center screw first and partially tighten it (see
b Insert the remaining screws.
c Tighten all six screws securely.
Be sure that the screws do not protrude from the cable manager mounting base and prevent the
cable guides from fitting properly over the base.
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
Top view of open/removed cover
Installing the BlackDiamond 10808 Cable Manager
Screws
Figure
EX_181
128).
199