Zr Xenpak - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

NOTE
The launch power (measured using the average power method used by power meters) is measured at the factory. The
average launch power minimum value is provided as a reference, not a pass/fail criterion.

ZR XENPAK

The ZR XENPAK supports SMF and has SC connectors.
The ZR XENPAK requires the software versions listed in
Table 70: ZR XENPAK software requirements
Switch Model
BlackDiamond Switches
BlackDiamond 10808
BlackDiamond 8800 series
BlackDiamond 12804
BlackDiamond 12802
Summit Switches
Summit X450 series
Summit X450a series
Summit X450e series
Table 71 lists specifications for the ZR XENPAK module
.
Table 71: ZR XENPAK module specifications
Parameter
Transmitter
Optical output power
Center wavelength
Receiver
Optical input power
Operating wavelength
General
Optical link loss
Optical dispersion
Distance
WARNING!
To prevent permanent damage to the ZR XENPAK and other equipment: always check the optical input power of the
receiver before inserting the fiber. The maximum optical input power for the receiver is -7 dBm. If you use optical
loopback for diagnostics purposes, the loopback requires a minimum of 10 dB optical attenuation. The
recommended attenuation range is 10 dB to 15 dB.
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
Required Software
ExtremeXOS 11.3.1 or later
ExtremeXOS 11.3.1 or later
ExtremeXOS 11.4 or later
ExtremeXOS 12.0 or later
ExtremeXOS 11.3.1 or later
ExtremeXOS 11.3.1 or later
ExtremeXOS 11.3.1 or later
Minimum Maximum
0 dBm 4 dBm
1530 nm 1565 nm
-22 dBm -7 dBm
1530 nm 1565 nm
11 dB 22 dB
0 ps/nm 1600 ps/nm
80 km
Table 70.
XENPAK Interfaces
357