Installing The Replacement Blackdiamond 8800 Series Fan Tray - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

CAUTION
Be sure that both hands are used to support the weight of the fan tray during removal.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch so that it is always available when you
need to touch ESD-sensitive components.

Installing the Replacement BlackDiamond 8800 Series Fan Tray

To install a replacement fan tray into the BlackDiamond 8800 series switch:
1 Attach the ESD-preventive wrist strap to your bare wrist and connect the metal end to the ground
receptacle on the top left corner of the switch.
2 Support the bottom of the fan tray with one hand as you lift the fan tray by the handle using the
other hand. Align the spare fan tray with the fan tray slot on the switch, and then slide the fan tray
into place in the switch (see
CAUTION
Always use both hands to support the weight of the fan tray during installation.
Figure 93: Installing the Fan Tray in the BlackDiamond 8810 Switch
BlackDiamond 8800 Series Switches Hardware Installation Guide
Figure 93 and Figure 94).
Fan Tray
Captive
Screws (x2)
Fan Tray
Handle
Replacing the Fan Tray
ASP030A
139