10G4Xa I/O Module; 10G4Ca I/O Module - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

10G4Xa I/O Module

Figure 26 shows the 10G4Xa I/O module.
Figure 26: 10G4Xa I/O module
Module status LEDs
The 10G4Xa I/O module has four XFP-based 10-gigabit Ethernet ports.
The default configuration of the 10G4Xa I/O module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
The 10G4Xa I/O module has the following LEDs:
Module status
●
Module diagnostics
●
Port status
●
For information about the LEDs and their activity on the 10G4Xa I/O module, see
on page 66.

10G4Ca I/O Module

Figure 26 shows the 10G4Ca I/O module.
Figure 27: 10G4Ca I/O module
Module status LEDs
The 10G4Ca I/O module has four 10-gigabit Ethernet ports that use CX4 interface connectors.
The default configuration of the 10G4Ca I/O module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
10GBASE-X XFP
10 Gbs ports
10GBASE-CX4
10 Gbs ports
I/O Modules
10G4Xa 10G4Xa
41612
BD_155
"I/O Module LEDs"
10G4Ca 10G4Ca 41613
BD_156
63