G60X Leds; G20X Module - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

G60X LEDs

The G60X module has the following LEDs:
Module status
●
Port status
●
For information about the LEDs and their activity on the G60X module, see
page 91.

G20X Module

Figure 41 shows the G20X module.
Figure 41: G20X module
The G20X module has 20 unpopulated mini-GBIC-based Gigabit Ethernet fiber ports. If you have one
MSM installed, all ports on the G20X module are switched through that MSM. If you have two MSMs
installed, the top 10 ports on the G20X module are switched through the MSM in slot A, and the bottom
10 ports are switched through the MSM in slot B during normal operation.
Using the G20X module allows you to fulfill line rate traffic.
All Gigabit Ethernet ports on these modules use SFP mini-GBIC connectors, either fiber or copper. The
module supports SFP fiber mini-GBICs 1000BASE-SX, 1000BASE-LX, 1000BASE-LX70, and 1000BASE-
ZX connectors. If you use SFP copper mini-GBICs, you must use the 1 Gigabit mini-GBIC; the G20X
module does not support copper 10/100/1000 SFP copper mini-GBICs.
The default configuration of the G20X module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
About the BlackDiamond 10808 I/O Modules
Module status LEDs
Mini-GBIC ports
Mini-GBIC ports
ASP036
"I/O Module LEDs" on
85