Chapter 9: Blackdiamond Ac Power Cord Retainers; Blackdiamond 8810 Ac Power Cord Retainer; Installing The Blackdiamond 8810 Ac Power Cord Retainer - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

9
C H A P T E R
The AC power cord retainers for BlackDiamond 8800 series switches hold the power connectors in the
power sockets and prevent accidental disconnection due to earthquakes, vibration, or other
disturbances.
This chapter includes the following sections:
BlackDiamond 8810 AC Power Cord Retainer on page 137
●
BlackDiamond 8806 AC Power Cord Retainer on page 140
●
WARNING!
These BlackDiamond switches do not have a switch for turning the power of the unit on and off. Power to
the switch is disconnected by removing the wall plug from the electrical outlet. Always be sure that all plugs and
electrical outlets are easily accessible.

BlackDiamond 8810 AC Power Cord Retainer

Connect all AC power cords before you install the power cord retainer.
You need a #2 Phillips screwdriver to install or remove the AC power cord retainer:

Installing the BlackDiamond 8810 AC Power Cord Retainer

To install the BlackDiamond 8810 AC power cord retainer:
1 Identify the power outlets on the front of the BlackDiamond 8810 switch (see
Figure 93: Power Outlets on the BlackDiamond 8810 Switch
BlackDiamond 8800 Series Switches Hardware Installation Guide
BlackDiamond AC Power Cord
Retainers
Figure 93).
ASP008
137