Rack Mounting The Blackdiamond 8810 Chassis - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Rack Mounting the BlackDiamond 8810 Chassis

To install the BlackDiamond 8810 chassis in a rack:
1 Locate the 19-inch helper bracket that is shipped with the chassis.
2 Identify the rack location where the chassis will be installed.
3 Using four rack-mounting screws, attach the helper bracket to the system rack immediately below
the chassis location as shown in
You must provide the screws for attaching the helper bracket.
Figure 51: Attaching the helper bracket to the system rack
4 Lift the back of the empty chassis onto the helper bracket.
5 Slowly guide the chassis into the system rack until the mounting brackets are flush against the rack
uprights.
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide

Rack Mounting the BlackDiamond 8810 Chassis

Figure 51.
EX_086A
101