Repacking The Blackdiamond 8806/12804 Chassis - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Repacking the BlackDiamond 8806/12804 Chassis

To repack the BlackDiamond 8806/12804 chassis:
1 Remove all modules and power supplies from the BlackDiamond 8806/12804 chassis. Follow correct
Extreme Networks procedures for removing components.
2 Using four rack mounting screws, attach the 19-inch helper bracket to the system rack immediately
below the chassis.
3 Remove the eight rack mounting screws that secure the chassis to the system rack.
4 On each side of the chassis, place one hand in the empty power supply bay and the other hand in
the rear slot on the back panel of the chassis.
CAUTION
Do not use the fan tray handle to lift or maneuver the BlackDiamond 8806/12804 chassis. This handle is not
designed to support the weight of the chassis.
5 Slowly guide the chassis out of the system rack using the helper bracket for support.
6 Carefully lift the chassis off the helper bracket and lower it onto the foam cushion in the shipping
carton base (see Figure
Figure 155: Setting the BlackDiamond 8806/12804 chassis onto the foam cushion
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
155.)

Repacking the BlackDiamond 8806/12804 Chassis

EX_129
231