Removing A Blank Front Panel - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Installing BlackDiamond Series Modules
Figure 113: Blank front panels in BlackDiamond series chassis
Blank
front panels
BlackDiamond 12808 chassis
3 Use a #2 Phillips screwdriver to tighten the captive screws at each end of the blank front panel.
NOTE
Tighten the screws of each installed blank front panel before inserting additional modules or blank front panels.
Otherwise, you might unseat modules or blank front panels that you have not secured.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you
need to touch ESD-sensitive components.

Removing a Blank Front Panel

To remove a BlackDiamond blank front panel:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the switch front panel.
On a BlackDiamond 12804 or 8800 series chassis or a BlackDiamond 12808 chassis, the ground
receptacle is at the top left corner.
On a BlackDiamond 12802 chassis, the ground receptacle is at the top right corner.
2 Loosen the captive screw at each end of the blank front panel, using a #2 Phillips screwdriver (see
Figure 114).
186
EX_074
BlackDiamond 8800 series or
12800 series chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
ASP018