Repacking The Blackdiamond 8810 Chassis - Extreme Networks BlackDiamond 8800 Series Hardware Installation Manual

Repacking a BlackDiamond Chassis

Repacking the BlackDiamond 8810 Chassis

To repack the BlackDiamond 8810 chassis:
1 Remove all modules and power supplies from the chassis. Follow correct Extreme Networks
procedures for removing components.
2 Using four mounting screws, attach the helper bracket to the system rack immediately below the
chassis.
3 Remove the eight mounting screws that secure the chassis to the system rack.
4 On each side of the chassis, place one hand in the empty power supply bay and the other hand in
the rear slot on the back panel of the chassis (see
CAUTION
Do not use the fan tray handle to lift or maneuver the BlackDiamond 8810 chassis. This handle is not designed to
support the weight of the chassis.
5 Slowly guide the chassis out of the system rack using the helper bracket for support.
6 Carefully lift the chassis off the helper bracket and lower it onto wood pallet as shown in
Figure 150: Correct method for lifting the BlackDiamond 8810 chassis
228
Figure 150).
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
Figure 150.
ASP017A