Snmp Host Table - D-Link DES-3526 Manual

The following parameters can set:
Parameter
Community Name
View Name
Access Right
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table,
click the under the Delete heading, corresponding to the entry you wish to delete.

SNMP Host Table

Use the SNMP Host Table window to set up SNMP trap recipients.
Open the SNMP Manager folder, located in the Security Management folder and click on the
SNMP Host Table link. This will open the SNMP Host Table window, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding X under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the
entry under the Host IP Address heading.
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand
corner of the window. This will open the SNMP Host Table Configuration window, as shown
below.
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Description
Type an alphanumeric string of up to 33 characters that is used to identify members of
an SNMP community. This string is used like a password to give remote SNMP
managers access to MIB objects in the Switch's SNMP agent.
Type an alphanumeric string of up to 32 characters that is used to identify the group
of MIB objects that a remote SNMP manager is allowed to access on the Switch. The
view name must exist in the SNMP View Table.
Read Only - Specifies that SNMP community members using the community string
created can only read the contents of the MIBs on the Switch.
Read Write - Specifies that SNMP community members using the community string
created can read from, and write to the contents of the MIBs on the Switch.
Figure 7- 35. SNMP Host Table window
149