Connecting The Switch
Switch To End Node
Switch To Hub or Switch
Connecting To Network Backbone or Server
Switch To End Node
End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ?45 Ethernet/Fast Ethernet Network
Interface Card (NIC) and most routers.
An end node can be connected to the Switch via a twisted-pair Category 3, 4, or 5 UTP/STP cable.
The end node should be connected to any of the ports of the Switch.
The Link/Act LEDs for each UTP port will light green or amber when the link is valid. A blinking
LED indicates packet activity on that port.
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
NOTE: All 24 high-performance NWay Ethernet ports can
support both MDI-II and MDI-X connections.
Figure 3- 1. Switch connected to an end node
Section 3
12