D-Link DES-3526 Manual page 106

To remove a previously created rule, select it and click the
click the Add button:
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters
Profile ID
Mode
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Figure 6- 60. Access Rule Table window
Figure 6- 61. Access Rule Configuration window (Ethernet)
Description
This is the identifier number for this profile set.
Select Permit to specify that the Switch, according to any additional rule, forwards the
packets that match the access profile added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
button. To add a new Access Rule,
93