Mstp Port Information - D-Link DES-3526 Manual

Instance Type
Instance Status
Instance Priority
Click Apply to implement changes made.

MSTP Port Information

STP can be set up on a port per port basis. To view the following window click Configuration >
Spanning Tree > MST Port Information:
In addition to setting Spanning Tree parameters for use on the switch level, the Switch allows for the
configuration of groups of ports, each port-group of which will have its own spanning tree, and will
require some of its own configuration settings. An STP Group will use the switch-level parameters
entered above, with the addition of Port Priority and Port Cost.
An STP Group spanning tree works in the same way as the switch-level spanning tree, but the root
bridge concept is replaced with a root port concept. A root port is a port of the group that is elected
based on port priority and port cost, to be the connection to the network for the group. Redundant links
will be blocked, just as redundant links are blocked on the switch level.
The STP on the switch level blocks redundant links between switches (and similar network devices).
The port level STP will block redundant links within an STP Group.
It is advisable to define an STP Group to correspond to a VLAN group of ports.
NOTE: If you want to enable Forwarding BPDU on a per port basis, the
following settings must first be in effect: 1. STP must be globally disabled
and 2. Forwarding BPDU must be globally enabled. These are the default
settings config rable in the STP Bridge Global Settings men disc ssed
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Displays the instance type(s) currently configured on the Switch. Each instance type
is classified by a MSTI ID. CIST refers to the default MSTI configuration set on the
Switch.
Displays the current status of the corresponding MSTI ID
Displays the priority of the corresponding MSTI ID. The lowest priority will be the root
bridge.
Figure 6- 28. STP Port Settings window
54