Features - D-Link DES-3526 Manual

This stand-alone Switch enables the network to use some of the most demanding multimedia and
imaging applications concurrently with other user applications without creating bottlenecks. The built-
in console interface can be used to configure the Switch's settings for priority queuing, VLANs, and
port trunk groups, port monitoring, and port speed.
NOTE: For the remainder of this manual both hardware versions of the Switch,
the DES-3526 and DES-3526DC will be referred to as simply the Switch or the
DES-3526 except where the differences are relevant.

Features

IEEE 802.3 10BASE-T compliant
•
IEEE 802.3u 100BASE-TX compliant
•
IEEE 802.1p Priority Queues
•
IEEE 802.3x flow control in full duplex mode
•
IEEE 802.3ad Link Aggregation Control
•
Protocol support.
IEEE 802.1x Port-based and MAC-based
•
Access Control
IEEE 802.1Q VLAN
•
IEEE 802.1D Spanning Tree, IEEE 802.1W
•
Rapid Spanning Tree and IEEE 802.1s
Multiple Spanning Tree support
Access Control List (ACL) support
•
Single IP Management support
•
Access Authentication Control utilizing
•
TACACS, XTACACS and TACACS+
Dual Image Firmware
•
Simple Network Time Protocol support
•
MAC Notification support
•
Asymmetric VLAN support
•
System and Port Utilization support
•
System Log Support
•
Support port-based enable and disable
•
High performance switching engine performs forwarding and filtering at full wire speed, maximum 14, 881
•
packets/sec on each 10Mbps Ethernet port, and maximum 148,810 packet/sec on 100Mbps Fast Ethernet port.
Full- and half-duplex for both 10Mbps and 100Mbps connections. Full duplex allows the switch port to
•
simultaneously transmit and receive data. It only works with connections to full-duplex-capable end stations and
switches. Connections to a hub must take place at half-duplex
Support broadcast storm filtering
•
Non-blocking store and forward switching scheme capability to support rate adaptation and protocol conversion
•
Supports by-port Egress/Ingress rate control.
•
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Address table: Supports up to 8K MAC
•
addresses per device
Supports a packet buffer of up to 3 Mbits
•
Supports Port-based VLAN Groups
•
Port Trunking with flexible load distribution
•
and fail-over function
IGMP Snooping support
•
SNMP support
•
Secure Sockets Layer (SSL) and Secure Shell
•
(SSH) support
Port Mirroring support
•
MIB support for:
•
RFC1213 MIB II
•
RFC1493 Bridge
•
RFC1757 RMON
•
RFC1643 Ether-like MIB
•
RFC2233 Interface MIB
•
Private MIB
•
RFC2674 for 802.1p
•
IEEE 802.1x MIB
•
RS-232 DCE console port for Switch
•
management
Provides parallel LED display for port status
•
such as link/act, speed, etc.
2