Snmp Host Table Settings - D-Link DGS-3700-12 User Manual

To implement changes made, click Apply. To delete an existing SNMP User Table entry, click the corresponding
Delete button.

SNMP Host Table Settings

This window is used to set up SNMP trap recipients.
To view this window, click Management > SNMP Settings > SNMP Host Table Settings, as shown below:
The following parameters can set:
Parameter
Host IP Address
User-based Security
Model
Security Level
Community String/
SNMP V3 User Name
To implement your new settings, click Apply.
SNMP v6Host Table Settings
This window is used to specify the IPv6 host IP address to which the trap packets will be sent.
To view this window, click Management > SNMP Settings > SNMP v6Host Table Settings, as shown below:
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 3- 34 SNMP Host Table Settings window
Description
Type the IP address of the remote management station that will serve as the SNMP host
for the Switch.
SNMPv1 – Specifies that SNMP version 1 will be used.
SNMPV2c – Specifies that SNMP version 2 will be used.
SNMPV3 – To specify that the SNMP version 3 will be used.
NoAuthNoPriv – To specify a NoAuthNoPriv security level.
AuthNoPriv – To specify an AuthNoPriv security level.
AuthPriv – To specify an AuthPriv security level.
Type in the community string or SNMP V3 user name as appropriate.
Figure 3- 35 SNMP V6Host Table Settings window
57