D-Link DES-3526 Manual page 157

The following parameters can set:
Parameter Description
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
Encrypted
To implement changes made, click Apply. To return to the SNMP User Table, click the
SNMP User Table Entries
DES-3526 / DES-3526DC Fast Ethernet Layer 2 Switch
Figure 7- 28. SNMP User Table Configuration window
Enter an alphanumeric string of up to 32 characters. This is used to identify the SNMP
user.
This name is used to specify the SNMP group created can request SNMP messages.
V1 - Specifies that SNMP version 1 will be used.
V2 - Specifies that SNMP version 2 will be used.
V3 - Specifies that SNMP version 3 will be used.
MD5 - Specifies that the HMAC-MD5-96 authentication level will be used. This field is
only operable when V3 is selected in the SNMP Version field and the Encryption field
has been checked. This field will require the user to enter a password.
SHA - Specifies that the HMAC-SHA authentication protocol will be used. This field is
only operable when V3 is selected in the SNMP Version field and the Encryption field
has been checked. This field will require the user to enter a password.
None - Specifies that no authorization protocol is in use.
DES - Specifies that DES 56-bit encryption is in use, based on the CBC-DES (DES-
56) standard. This field is only operable when V3 is selected in the SNMP Version
field and the Encryption field has been checked. This field will require the user to
enter a password between 8 and 16 alphanumeric characters.
Checking the corresponding box will enable encryption for SNMP V3 and is only oper-
able in SNMP V3 mode.
link.
144
Show All