CYBEX Treadmill Owner's Service Manual page 84

E. Using needle nose pliers, plug each brush wire onto the fast-on inside the rectangular
access hole.
15. Secure the drive motor access panels.
A. Squeeze each rectangular brush covers, insert it into the holes and then release.
B. Push the round brush cover into its hole until it is flush with the motor. NOTE: If a cover
is damaged, order Cybex replacement part number EH-16954 for the round cover or
EH-16955 for the rectangular cover.
16. Secure the drive motor (new or old).
A. Carefully lower the drive motor in position. Place the drive belt loosely around the drive
pulley. See Figure 9. NOTE: Do not crush the speed sensor or scratch the speed decal
on the flywheel.
B. Turn the motor so the exit cable is oriented at a 1 o'clock angle toward the back of the
treadmill. See Figures 11 and 12.
C. Slip the drive belt around the drive pulley and be sure the motor and belt are straight.
D. Using a 7/16" open end wrench, tighten the motor strap on the motor and be sure the
buckle is closed.
17. Connect the motor cables.
A. Connect the motor cables into the lower board in the following manner: red goes to A1,
black goes to A2, yellow goes to BW and green goes to the line filter's left upper fast-on
location. See Figure 11.
B. Place the flat washer on the
motor saddle and follow it
with the ground terminal, split
washer and screw. See
Figure 12. NOTE: Be sure
that the spacers are still in
place below the saddle.
C. Using a 1/2" socket wrench,
tighten both screws on the
motor saddle.
D. Refer to the lower board shield
to confirm the locations for the
connectors and check to see
that all of the cables are
connected firmly. See Figure
14.
E. Place the lower board shield
in position and push the clips
down. NOTE: The clips will
snap in. See Figure 14.
Page 7-18
Cybex Pro Treadmill Owner's & Service Manual
Clips (3)
Lower
Board
Shield
Figure 14
PL-17052-4