Display Overlays - CYBEX Treadmill Owner's Service Manual

C. Push the display cable down through the handrail and out the handrail's bottom hole.
NOTE: Twisting the cable as you push will help it go through.
D. Push the display cable down through the upright and out the exit hole. NOTE: There is
a black line on the display cable to show you how far to pull out the cable. When you
see the line, stop pulling the cable out.
E. Route the cable into the access hole.
F. Connect the display cable to the lower control board at P1 and P2.
7. Secure the cable.
A. Using a Phillips head screwdriver, open the clip described in step 5D and secure the
cable in the clip.
B. Locate the line on the display cable described in step 6D and tie the cable with the
wire tie near the bottom of the upright.
C. Open the wire holder at the junction, put the cable inside and close the wire holder.
D. Check to see that all of the connectors are connected firmly in their proper place.
E. Place the lower board shield in position and push the clips down. NOTE: The clips will
snap in.
8. Secure the left junction covers.
A. Using an Phillips screwdriver, tighten the three screws that hold the junction
covers in place.
9. Secure the motor cover.
A. Lower the motor cover center into position. See Figure 2.
B. Using a Phillips head screwdriver, tighten the three screws on each side. NOTE: Be
sure the screws are catching the center motor cover's holes.
10. Secure the console back.
A. While being sure not to pinch any cables, attach the top console back to the console
front with the five Phillips head screws.

Display Overlays

NOTE: This procedure will cover the upper and/or lower display overlay. They are removed
and replaced the same on the Pro treadmill.
Tools Required
• Phillips head screwdriver
• ESD (Electro Static Discharge) grounding strap
• Razor blade
Page 7-34
Cybex Pro Treadmill Owner's & Service Manual