CYBEX Treadmill Owner's Service Manual page 78

B. Be sure the drive belt is around the drive pulley and the front roller before attaching the
front roller. NOTE: The drive belt should be straight.
C. Using a 9/16" socket wrench with a 3" extension, attach the two screws that fasten
the front roller to the frame. NOTE: Tighten each of the two screws evenly, making sure
not to tighten one screw too many turns before moving to the other screw.
14. Secure the drive belt tension. (Follow this step only if you replaced the drive belt.)
A. Using a 1/2" socket wrench, tighten the two screws on the motor saddle. See
Figure 9.
15. Secure the running deck.
A. Place the deck in position as noted in step 9A. NOTE: Make a note of the service you
performed on the Service Schedule under the motor cover.
B. Using a 7/16" open end or socket wrench, attach the ten washers and screws that hold
the deck to the treadmill frame. See Figure 7.
16. Secure the rear roller.
A. Slide the rear roller into the running belt. See Figure 6.
B. Slide the hardware for each side into position.
NOTE: Place the end of the bolt in first and
then hold the rear roller up while you pivot the
group of hardware into the rear roller slot. Be
sure the bronze bushing is touching the head of
the bolt. See Figure 10.
C. Using a 3/4" socket wrench, tighten each rear
roller bolt evenly, making sure not to tighten
either bolt too many turns before moving to
the other bolt. When properly tensioned, the
space between the inner face of the bracket
and the nut holder should measure 1.25" (3.2
cm). See Figure 10.
17. Secure the top steps.
A. Place each top step in position on the frame. See Figure 4.
B. Using a Phillips head screwdriver, tighten the three screws that hold each top step in
place. See Figure 4.
18. Secure the end caps.
A. Using a Phillips head screwdriver, tighten the screw that holds each end cap in place.
See Figure 4.
19. Secure the side panels.
A. Place each side panel into position slightly under the end cap and use your hand to
push all along the bottom edge of the side panel to snap it in place. See Figure 5.
Page 7-12
Cybex Pro Treadmill Owner's & Service Manual
Inner Face
Nut Holder
of Bracket
1.25"
(3.2 cm)
Figure 10
Bronze
Bushing