CYBEX Treadmill Owner's Service Manual page 92

8. Connect the line filter cables (if applicable).
A. Connect the white cable to the front right fast-on on the line filter and route it through
the access hole.
B. Connect the black cable to the front left fast-on on the line filter and route it through
the access hole.
C. Connect the ends of these two cables to the lower board. The white connects to the
fast-on labeled AC Line 1. The black connects to the fast-on labeled AC Line 2.
D. Connect the drive motor cable (green) to the line filter's front left fast-on connector.
9. Route the power cord.
A. Route the power cord behind the base brackets and route the fast-ons out the power
switch access hole. NOTE: The power cord can exit the front or back of the treadmill.
Position it the way you intend to leave it.
10. Connect the power cable.
A. Hold the power switch and its plate so that the I (on) is toward the top. See Figure 18.
Access Hole
Figure 18
B. Connect these two power cord cables to the power switch:
- The blue cable connects to the top left switch fast-on.
- The brown cable connects to the top right switch fast-on.
NOTE: You will connect the ground in step 10D.
C. Connect the line filter fast-ons to the power switch.
- The white cable connects to the bottom right switch fast-on.
- The black cable connects to the bottom left switch fast-on.
D. With the ground wire through the access hole to the lower control bracket, put the
ground wire terminal on the stud on the lower board bracket.
Page 7-26
Cybex Pro Treadmill Owner's & Service Manual
Brown
Blue
Shown From
Front of Switch
with "I" Toward
Black White
Power Cord
Behind Base
Brackets
the Top