CYBEX Treadmill Owner's Service Manual page 43

Cybex Pro Treadmill Owner's & Service Manual
Figure 3
4. Remove the side panels.
A. Pull each side panel out and off the treadmill. See Figure 3.
5. Remove the top steps.
A. Using a Phillips
head screwdriver,
remove the three
screws that hold
each top step in
place. See Figure 4.
B. Grasp each top
step and lift it out
and off the
treadmill. See Figures 3 and 4.
6. Check the belt and deck condition.
A. Look at the edges of the belt while you roll it by hand. If the belt has
any rips or looks excessively worn the belt needs to be replaced.
B. Run your hand under the belt on the top of the deck surface. If you feel
excessive ridges or cracks, or if the deck feels grooved yet highly
polished, the deck should be flipped to an unused surface or replaced.
In time, a worn belt and deck can cause high current draw and
ultimately, motor failure. For instructions on replacing the belt and deck,
see Running Belt and Deck in the Service chapter.
7. Clean under the belt.
A. To minimize the effect of friction between the deck and the running belt,
Cybex recommends cleaning the underside of the running belt and the
top of the running deck surface by wiping them with a clean, dry towel.
This cleaning should be done each time you check the belt and deck
condition to prevent premature wear of the deck, running belt and the
drive motor system. See the Service Schedule in this chapter.
Top Steps
Side Panel
Screws (3 Under Each Top Step)
Figure 4
Side Panel
End Caps
Screws
Table of Contents . . . . . . . . . . . . . iii
4 Preventive Maintenance
Warnings/Cautions. . . . . . . . . . . . 4-1
Regular Maintenance . . . . . . . . . 4-1
Cleaning Your Treadmill . . . . . . . . 4-1
Running Belt Maintenance. . . . . . 4-2
Other Preventive Maintenance. . . 4-6
Service Schedule . . . . . . . . . . . . . 4-7
Log Sheet. . . . . . . . . . . . . . . . . . . 4-8
Page 4-5