CYBEX Treadmill Owner's Service Manual page 41

Cybex Pro Treadmill Owner's & Service Manual
often to prevent premature wear of the deck, running belt, and the drive motor
system. See the Service Schedule in this chapter to determine the minimum
recommended cleaning.
Figure 1
The running belt may become loose and slip on the drive roller with each foot
plant. If it does, follow the Tensioning and Centering the Belt in this chapter.
See the Service Schedule in this chapter for a minimum schedule for checking
the belt tension.
Tension and Center the Belt — If the belt is slipping under each step perform
this procedure:
Tools Required
• 3/4" Socket wrench
1. Tension the belt.
A. Use a 3/4" socket wrench to turn each bolt 1/2 turn clockwise. See
Figure 1. NOTE: Be sure to adjust each bolt equally on each side.
B. Turn the power on and press the Quick Start key.
C. Press the Speed
Allow the treadmill to run for a minute.
D. Observe the belt to be sure it stays centered. If it is not centered follow
step 2.
E. Walk on the belt to see if it still slips. If it does restart this procedure at
step 1 A. If you have to do this procedure three times and it still slips
check the drive belt tension in the Service chapter or call Cybex
Customer Service. Follow the next step to be sure the belt is centered.
! CAUTION: Be careful not to over tighten the belt. Over tightening the
belt can cause the belt to stretch and require replacement.
2. Center the belt.
NOTE: While centering the belt choose one bolt to adjust. Do not adjust
both bolts.
+
to bring the speed up to 3.5-4 mph (5.6-6.4 kph).
Table of Contents . . . . . . . . . . . . . iii
4 Preventive Maintenance
Warnings/Cautions. . . . . . . . . . . . 4-1
Regular Maintenance . . . . . . . . . 4-1
Cleaning Your Treadmill . . . . . . . . 4-1
Running Belt Maintenance. . . . . . 4-2
Other Preventive Maintenance. . . 4-6
Service Schedule . . . . . . . . . . . . . 4-7
Log Sheet. . . . . . . . . . . . . . . . . . . 4-8
Page 4-3