CYBEX Treadmill Owner's Service Manual page 94

Upper Display Board
Display Cable Ports
Lower Display Board
Figure 19
4. Attach the display board.
A. Place the display board in position and gently push the display board down into the
CSAFE board connector.
B. Using a Phillips head screwdriver, secure the four screws that hold the display board
to the console.
5. Connect the cables.
A. Connect these cables into the display board: the display cable (2 connectors), the two
upper switch membranes, the lower switch membrane, the contact heart rate cable
and the upper to lower board jumper. See Figure 19.
6. Check the connections.
A. Check to see that all of the cables are connected firmly in their proper place.
7. Secure the console back.
A. While being sure not to pinch any cables, use a Phillips head screwdriver to secure the
three screws that hold the bottom back cover to the console front.
8. Calibrate speed.
A. Follow the Speed Calibration procedure in this chapter.
Page 7-28
Cybex Pro Treadmill Owner's & Service Manual
Upper Switch Membrane Ports
RJ-45 Port
Contact Heart
CSAFE Board
Rate Port
Connects to
Display Board
CSAFE
Jumper
Lower Switch
Upper to
Membrane
Lower Board
Jumper
Heart Rate
Board