Planet Networking & Communication MH-1000 User Manual page 67

Multi-Homing Security Gateway User's Manual
Auto: The device will automatically apply the tunnel to WAN1 or WAN2 depending on which WAN
interface is active when the IPSec tunnel is being established. (Note: Auto only applies to Fail Over mode.
For Load Balance mode, please do not select "Auto". In Load Balance mode, Auto will be forced to WAN1
interface if Auto is selected.)
Pre-shared Key: This is for the Internet Key Exchange (IKE) protocol. IKE is used to establish a shared
security policy and authenticated keys for services (such as IPSec) that require a key. Before any IPSec
traffic can be passed, each router must be able to verify the identity of its peer. This can be done by
manually entering the pre-shared key into both sides (router or hosts).
Connection Type:
There are 5 connection types:
(1)LAN to LAN: MH-1000 would like to establish an IPSec VPN tunnel with remote router using Fixed
Internet IP or domain name by using main mode.
Secure Gateway Address (or Domain Name): The IP address or hostname of the remote VPN gateway.
Remote Network: The subnet of the remote network. Allow you to enter an IP address and netmask.
Back: Back to the Previous page.
Next: Go to the next page.
(2)LAN to Mobile LAN: MH-1000 would like to establish an IPSec VPN tunnel with remote router using
Dynamic Internet IP by using aggressive mode.
- 63 -