Planet Networking & Communication MH-1000 User Manual page 46

Username: Enter your user name.
Password: Enter your password.
Retype Password: Retype your password.
Connection: Select whether the connection should Always Connect or Trigger on Demand.
Always Connect: If you want the router to establish a PPPoE session when starting up and to
-
automatically re-establish the PPPoE session when disconnected by the ISP.
Trigger on Demand: If you want to establish a PPPoE session only when there is a packet
-
requesting access to the Internet (i.e. when a program on your computer attempts to access
the Internet).
Idle Time: Auto-disconnect the router when there is no activity on the line for a predetermined period of
time. Select the idle time from the drop down menu. Active if Trigger on Demand is selected.
IP Assigned by your ISP: If your IP is dynamically assigned by your ISP, select the Dynamic radio button.
If your IP assigns a static IP address, select the Static radio button, and input your IP address in the blank
provided.
MAC Address: If your ISP requires you to input a WAN Ethernet MAC, check the checkbox and enter your
MAC address in the blanks below.
DNS: If your ISP requires you to manually setup DNS settings, check the checkbox and enter your primary
and secondary DNS.
RIP: To activate RIP, select Send, Receive, or Both from the drop down menu. To disable RIP, select
Disable from the drop down menu.
MTU: Enter the Maximum Transmission Unit (MTU) for your network.
Click Apply to save your changes. To reset to defaults, click Reset.
Multi-Homing Security Gateway User's Manual
- 42 -