Planet Networking & Communication MH-1000 User Manual page 49

4.4.2.2 Bandwidth settings
Under Bandwidth Settings, you can easily configure both inbound and outbound bandwidth for each WAN
port.
WAN1: Enter your ISP inbound and outbound bandwidth for WAN1.
WAN2: Enter your ISP inbound and outbound bandwidth for WAN2.
NOTE: These values entered here are referenced by both QoS and Load Balancing functions.
4.4.3 Dual WAN
In this section, you can setup the fail over or load balance function, outbound load balance or inbound load
balance function, or setup specific protocol to bind with specific WAN port. In this menu are the following
sections: General Settings, Outbound Load Balance, Inbound Load Balance, and Protocol Binding.
4.4.3.1 General Settings
Multi-Homing Security Gateway User's Manual
- 45 -