Table of Contents
Advertisement
3.4 Factory Default Settings
3.4.1 User name and password
The default user name and password are "admin" and "admin" respectively.
If you ever forget your user name and/or password, you can restore your MH-1000 to its factory settings by
holding the Reset button on the back of your router until the Status LED begins to blink. Please note that
doing this will also erase any previous router settings that you have made. The Status LED will remain solid
as the device boots. Once the boot sequence is complete, the LED will shut off, indicating that MH-1000 is
ready.
3.4.2 LAN and WAN Port Addresses
The default values for LAN and WAN ports are shown below:
LAN Port
192.168.1.1
IP address
255.255.255.0
Subnet Mask
Enabled
DHCP server
function
100 IP addresses continuing
IP addresses for
from 192.168.1.100 through
distribution to
192.168.1.199
PCs
3.5 Information from Your ISP
3.5.1 Protocols
Before configuring this device, you have to check with your ISP (Internet Service Provider) to find out what
kind of service is provided such as DHCP, Static IP, PPPoE, or PPTP. The following table outlines each of
these protocols:
Configure this WAN interface to use DHCP client protocol to get an IP
address from your ISP automatically. Your ISP provides an IP address to the
DHCP
router dynamically when logging in.
Configure this WAN interface with a specific IP address. This IP address
Static IP
should be provided by your ISP.
PPPoE (PPP over Ethernet) is known as a dial-up DSL or cable service. It is
designed to integrate the broadband services into the current widely
PPPoE
deployed, easy-to-use, and low-cost dial-up-access networking
infrastructure.
Multi-Homing Security Gateway User's Manual
WAN Port
The DHCP Client is enabled to
automatically get the WAN port
configuration from the ISP.
- 25 -
Advertisement
Table of Contents
