Command Tables, Load; Current Edit Session, Save; Helvc N Ugfont - Intermec 3440 User Manual

HelvC

Command Tables, Load

Purpose: Downloads a command table, with t as the command table identifier. This
command table identifier is followed by the nibblized command entries
(c1-cn) to be loaded into the table. To change an entry in the table, the entire
table must be sent to the printer as a string of ASCII characters in
hexadecimal form. Any entry you do not redefine retains its old value. The
printer expects two hex digits for every entry in the table.
Syntax:
C[ t ], [ command 1 ], [ command 2 ], ..., [ command n ]
The command table identifier is t. The range is 0 to 4.
Data must be nibblized ASCII characters ranging from 0 to 9 and A to F.
Notes: New commands become effective after you repower or reset the printer. See
the command tables at the end of this chapter under "User-Defined
Interface Tables."
To modify only a few commands, send the <ESC>Z command, capture the
output, modify it, and send it back to the printer.

Current Edit Session, Save

Purpose: Saves the current page, format, UDC, or UDF being edited. The printer
remains in Program mode.
Syntax:
N
Notes: The printer automatically saves the current page, format, UDC, or when
you call a new one or when you exit Program mode.
C o d e 3 9
N
ugFont
Program Mode Commands
*1233*
FG 9pt Italic
6
6-71