Starting Communications; Ending Communications - Symbol Series 3100 Product Reference Manual

Series 3100 / 3500 Product Reference Guide

Starting Communications

1. The terminal displays:
2. Press <ENT> on the terminal.
3. Press <ENTER> on the host computer. SENDHEX begins transmitting the
program image. When communications are established, the terminal displays:
During program loading, the display shows the program segment address being
transferred (XXXX).
4. When the transmission is complete, the terminal displays:
A status of 0000 (all zeros) indicates a successful transfer. Other status values
indicate an error. These values are provided in Appendix C.
If you received an error, press <Clear> on the terminal to return to the Command
Mode main menu.

Ending Communications

1. Press <Clear> on the terminal.
2. Power down the terminal.
3. Detach any cables connected to the terminal.
4. Reboot the terminal using the appropriate cold boot sequence described in
Chapter 4 in the section Booting a Terminal.
2-10
Comm Parameters
Start? <ENT>
Program loader
Receiving: XXXX
Program loader
Status 0000