Terminal Attempts To Associate With Access Point - Symbol Series 3100 Product Reference Manual

- Default Router
- Terminal IP Address
and press <ENTER> after each entry.
Your changes are saved in the nonvolatile area on the
Note:
radio card. The values just entered are not lost if you
reboot the terminal.
5. Select Exit from the Configurator Menu and press <ENTER> to exit the
Configurator to continue the connection process.

Terminal Attempts to Associate with Access Point

The terminal attempts to associate with an Access Point (AP) using the default Net Id.
If Terminal Association with AP Is Not Successful
If the terminal is unable to associate with the AP (the Net Id is wrong or forgotten), it
displays the message:
for a few seconds. A second message follows:
The terminal continues trying to connect until attempt is cancelled.
To cancel and set up a new Net Id (obtained from the Network Administrator):
1. Press <Ctrl+C> to end the attempt. The terminal displays the message:
2. Type Y to exit to the DOS prompt (D:).
3. At the DOS prompt, type CFG24 and press <ENTER> to initiate the Configurator
and bring up the Configurator screen:
STAT24 Ver 1.XX
NOT Associated
Terminal cannot associate with AP. You're
out of range or not configured. Ctrl+C to end
or other key to retry. Strike any key when ready.....
Halt Batch process Y/N?
CONFIGURATOR 1.XX
View config params
Net Id
Subnet Mask
Default Router
Introduction to Spectrum24 RF Terminals
3-9